Troubleshooting - Fellowes POWERSHRED P-58Cs Manual

BASIC SHREDDING OPERATION
Disconnect power switch
must be in ON (I) position to
operate shredder. Insert waste
bag (Fellowes #36052) for
easy disposal.
Continuous operation:
3-5 minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
3-5 minutes will trigger a
15-minute cool down period.

TROUBLESHOOTING

Paper jam:
Set to Off (O), remove shredder head and empty bin. Replace shredder head, and follow any or all of the below procedures.
1 2
Set to Reverse (R) Alternate slowly back and forth
for 2-3 seconds
ATTENTION: If the SafeSense ® light remains on, you must engage the
SafeSense ® feature. (See SafeSense
SafeSense paper jam: If the SafeSense
®
the SafeSense ® feature and clear the paper. Warning – when switch is in override position, the
SafeSense ® light will flash and the SafeSense
reset the SafeSense ® feature.
BASIC PRODUCT MAINTENANCE
OILING SHREDDER
performance. If not oiled, a machine may
experience diminished sheet capacity, intrusive
noise when shredding and could ultimately
stop running. To avoid these problems, we
recommend you oil your shredder each time
you empty your waste bin.
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of defects in
material and workmanship and provides service and support for 2 years from the date of purchase by the
original consumer. Fellowes warrants the cutting blades of the machine to be free from defects in material and
workmanship for 5 years from the date of purchase by the original consumer. If any part is found to be defective
during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes' option
and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling, failure to comply
with product usage standards, shredder operation using an improper power supply (other than listed on label),
or unauthorized repair. Fellowes reserves the right to charge the consumers for any additional costs incurred by
PAPER
1 2
Check paper
Set to Off (O) and
amount
plug in
CARD
2
1
Set to Auto-On (I)
Set to Off (O) and
plug in
4
3
Set to Off (O)
and unplug
® instructions below.)
feature activates (SafeSense
®
® feature will NOT function. Once the paper is cleared,
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
2
Set to Off (O)
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
3
Set to Auto-On (l)
3
Hold card at edge
6
5
Gently pull uncut Set to Reverse (R)
paper from paper
entry. Plug in.
Override Switch
light remains on) to cause
®
Override Switch to deactivate
3
Set to Reverse (R)
* Apply oil
2-3 seconds
across entry
Fellowes to provide parts or services outside of the country where the shredder is initially sold by an authorized
warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide,
to obtain service under this warranty, please contact us or your dealer.
4 5
Feed into paper entry
Set to Off (O)
and release
and unplug
4 5
Feed into center of Set to Off (O)
entry and release and unplug
Indicator lights:
Yellow - SafeSense
Yellow flashing - SafeSense
Make sure head is on basket correctly
Wait 15 minutes for motor to cool down
Remove and empty basket
Sensor light illuminated–paper
SafeSense ® override switch
Active Not active
active
®
not active
®
3