Inspection - MULTIQUIP DLW400ESA4 Operation Manuals

LUBRICATION OIL
Fill the engine crankcase with lubricating oil through the
filler hole, but DO NOT overfill. Make sure the generator is
level and verify that the oil level is maintained between the
two notches (Figure 11) on the dipstick. See Table 10 for
proper selection of engine oil.
Figure 11. Engine Oil Dipstick
When checking the engine oil, be sure to check if the oil is
clean. If the oil is not clean, drain the oil by removing the
oil drain plug, and refill with the specified amount of oil as
outlined in the Kubota Engine Owner's Manual. Oil should
be warm before draining.
When low sulfur or ultra low diesel fuel is used, it is
recommended that CF-4 or CG-4 (classification) engine
oil be used. Reference Table 10 when replacing engine oil.
Table 10. Recommended Motor Oil
FUEL CHECK
DANGER
Fuel spillage on a hot engine can cause
a fire or explosion. If fuel spillage occurs,
wipe up the spilled fuel completely to
prevent fire hazards. NEVER smoke
around or near the generator.
DLW400ESA4 WELDER/GENERATOR • OPERATION MANUAL — REV. # 0 (03/14/18) — PAGE 29
REFILLING THE FUEL SYSTEM
CAUTION
ONLY properly trained personnel who have read
and understand this section should refill the fuel tank
system.
1. Lift the control panel lid and fold backwards.
2. Next, insert the ignition key into the starter switch and
place in the RUN position.
3. Read the fuel guage status LEDs (Figure 12) on the
control panel and determine if the fuel level is low.
Reference Table 11 for LED fuel gauge level indication.
4. Place ignition key in STOP position and remove ignition
key from starter switch.
Figure 12. Fuel Gauge
Table 11. Fuel Gauge LEDs
LED # LED Color
Red (Empty)
1
Green
2 Green
3 Green
4 Green
5 Green
6 Green
7 Green (Full)
If fuel level is low, ALWAYS fill the fuel tank with clean fresh
low sulfur or ultra low sulfur diesel fuel. No. 2 diesel fuel
can be used as an alternative. DO NOT fill the fuel tank
beyond its capacity.
Pay attention to the fuel tank capacity when replenishing
fuel. The fuel tank cap must be closed tightly after filling.
Handle fuel in a safety container. If the container does
not have a spout, use a funnel. Wipe up any spilled fuel
immediately.

INSPECTION

Fuel Tank Level
gal. (liters)
0~ 2.4 (0 ~ 9)
2.4~ 3.4 (9 ~ 12.8)
3.4~4.8 (9.0 ~ 18.1)
4.8~5.8 (18.1 ~ 22)
5.8~6.9 (22 ~ 26.1)
6.9~7.9 (26.1 ~ 29.9)
7.9~9.2 (29.9 ~ 34.8)
9.2~11.1 (34.8 ~ 42.0)