Check the insulation of the motor and the motor
cable.
If the drive is about to be connected to an IT
(ungrounded) system, check that the drive is not
equipped with EMC filter +E202.
Route the cables.
Install the drive. Connect the power cables. Connect
the control and the auxiliary control cables.
Check the installation.
Commission the drive.
Commission the optional brake chopper (if present).
Product and service inquiries
Address any inquiries about the product to your local ABB representative, quoting
the type code and serial number of the unit in question. A listing of ABB sales,
support and service contacts can be found by navigating to ABB website and
selecting Drives – Sales, Support and Service network on the right pane.
Product training
For information on ABB product training, navigate to ABB website and select
Drives – Training courses on the right pane.
Providing feedback on ABB Drives manuals
Your comments on our manuals are welcome. Go to ABB website, then
select successively Drives – Document Library – Manuals feedback form on the right
pane.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Task
See
Installation:
Checking the insulation of the
installation
The ACS800-02/U2:
Type
instructions on how to disconnect the EMC
filtering, contact ABB.
Planning the electrical installation:
cables
For compliance with the European Union EMC
Directive, see
Technical
data:
Installation, Resistor braking
Installation checklist
Appropriate firmware manual
Resistor braking
21
code. For
Routing the
CE marking
(optional)
About this manual