Electrical Components - Pride C1 Owner's Manual

LIFT CHAIR SERIES
Lift Mechanism: Responds to the hand control commands to position the chair in the sit, recline, and stand
positions.
Leg Levelers: Manually rotate up or down in order to stabilize the chair before use (Fig. 3.2).
Figure 3.2 Leg Levelers
Scissor Mechanisms: Extend or retract to take the
chair through the various stages of recline (Fig. 3.3).
WARNING!
Hazard! Be aware that the lift
mechanism
mechanisms are a pinch point on
the lift chair. Keep the following
items and similar objects clear of
these points when operating the
lift chair:
appendages
small children
pets
wires
oxygen tubes
loose items, including but not
limited to clothing and blankets
electrical power leads

ELECTRICAL COMPONENTS

Your Pride Lift Chair is equipped with a low voltage DC electrical system that reduces the standard household
alternating current of 90V AC - 264V AC to direct current (24/39V DC). The electrical components include the
external transformer, batteries, and hand control. Keep these areas free from moisture at all times.
WARNING! Keep all electrical components free from moisture at all times to
prevent shock and/or electrical hazard.
External Transformer: Connects to a standard electrical outlet to provide power to the lift chair. The trans-
former may be equipped with an LED indicator, which shows green when power to the transformer is on.
The external transformer may also come equipped with mounting brackets that allow the transformer to be
mounted to the wall directly under the standard electrical outlet. The screws must be mounted to the wall stud
for security. Refer to "Appendix G" or "Appendix H" for a mounting diagram.
NOTE: Pride is not responsible for damage due to improper installation.
10
ROTATE THE LEG LEVELERS TO RAISE OR LOWER THE CHAIR.
Pinch/Crush Points
and scissor
www.pridemobility.com
Figure 3.3 Scissor Mechanism
III. YOUR LIFT CHAIR
SCISSOR
MECHANISM
(PINCH POINT)
Lift Chair Series