Advertisement
Advertisement
Table of Contents
Related Manuals for Razor MX350 15128050
Summary of Contents for Razor MX350 15128050
- Page 1 OWNER’S MANUAL Read and understand this entire manual before riding! Item Numbers: Dirt Rocket MX350 15128050 Dirt Rocket MX500 15128190 Dirt Rocket MX650 15165070...
-
Page 2: Table Of Contents
Razor USA recommends that you periodically review and reinforce the information in this manual with younger riders, and that you inspect and maintain your children’s vehicle to insure their... -
Page 3: Estimated Assembly/Set-Up Time
2.5mm, 4mm and 5mm hexagonal key wrenches (included) Need Help? Visit our web site for updates and a list of authorized service centers at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time. Rear Brake Lever... -
Page 4: Assembly And Set-Up
ASSEMBLY AND SET-UP Charging the Battery Your electric motorbike may not have a fully charged battery; therefore it is a good idea to charge the battery prior to use. • Initial charge time: 12 hours • Recharge time: up to 8 hours, depending on the level of depletion Charger Port... - Page 5 ASSEMBLY AND SET-UP Installing the Front Wheel – MX500 / MX650 Nut Washer Position wheel in front fork and slide disk brake into caliper. axle through fork, spacer washer and though wheel hub. When axle passes through the other side of the wheel hub, add the other spacer washer and slide though the fork.
-
Page 6: Repair And Maintenance
If brake is not engaging properly, follow instructions for adjusting the brakes outlined below. REPAIR AND MAINTENANCE Check the Razor web site for any updates on the latest repair and maintenance procedures. Turn power switch off before conducting any maintenance procedures. - Page 7 REPAIR AND MAINTENANCE q Chain and Rear Tire Replacement – MX350 Tools required: 10mm wrench, two (2) 8mm wrenches, and two (2) 17mm wrenches. Loosen screws and remove chain guard. loosen the brake cable anchor and disconnect the cable. With two 17mm wrenches, loosen the axle.
- Page 8 REPAIR AND MAINTENANCE q Chain and Tire Replacement – MX500 / MX650 Tools required: Phillips screwdriver and two (2) 17mm wrenches. Loosen screw and remove attaching wrenches to both axle chain guard. nuts and loosening counter- clockwise. Pull the wheel out. Note the arrangement of the hardware wheel by slipping the chain sequence.
- Page 9 WARNING: Regularly check the spoke tension and retighten the spokes whenever loose. If you have any doubt, ask an experienced motorcycle or bicycle mechanic to inspect your spokes to determine if the spokes need tightening or adjusting. Tightening each nipple...
- Page 10 CONTAINS SEALED LEAD BATTERY. BATTERY MUST BE RECYCLED. Disposal: Your Razor product uses sealed lead-acid batteries which must be recycled or disposed of in an environmentally sound manner. Do not dispose of a lead-acid battery in a fire. The battery may explode or leak.
- Page 11 SB 1918 (CALIFORNIA) DECLARATION YOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF THIS SCOOTER/ELECTRIC VEHICLE. TO DETERMINE IF COVERAGE IS PROVIDED, YOU SHOULD CONTACT YOUR INSURANCE COMPANY OR AGENT.
-
Page 12: Troubleshooting Guide
Make sure power flow to the wall outlet is on. You may check to see if your charger is working by using a volt meter or asking your local Razor authorized service center to test your charger for you. Check all wires and connectors to make sure they are tight. - Page 13 Chain is too dry noises or grinding sounds Need Help? Visit our web site for updates and a list of authorized service centers at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time. Solution Check all wires around the motors and all connectors to make sure they are tight.
-
Page 14: Mx350 Parts
MX350 PARTS Keep your MX350 running for years with genuine Razor parts. Visit our web site or e-mail us for more information on spare part availability. (Specifications subject to change without notice.) Handlebar end cap Grip, half length Speed control, twist grip... - Page 15 MX350 PARTS...
-
Page 16: Mx500 / Mx650 Parts
MX500 / MX650 PARTS Keep your MX500/MX650 running for years with genuine Razor parts. Visit our web site or e-mail us for more information on spare part availability. (Specifications subject to change without notice.) Fender, front Cover, handlebar pad Handlebar foam padding... - Page 17 MX500 / MX650 PARTS...
-
Page 18: Safety Reminders
Need Help? Visit our web site for updates and a list of authorized service centers at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time.