Installing The Chassis Ground Connection - Cisco NCS 4201 Installing Manual

Hide thumbs Also See for NCS 4201:

Hardware installation manual (94 pages)

Table of Contents

Installing the Cisco NCS 4201

Step 4

Grasp the SFP module between your thumb and index finger, and carefully remove it from the module slot.

Step 5

For fiber-optic SFP modules, insert a dust plug into the optical ports of the SFP module to keep the optical interfaces

clean.

Step 6

Place the removed SFP module in an antistatic bag or other protective environment.

Connecting to SFP Modules

This section describes how to connect to SFP modules. For instructions on how to connect to fiber-optic SFP

modules, see the

For instructions about how to install or remove an SFP module, see the

section.

Connecting to Fiber-Optic SFP Modules

Follow these steps to connect a fiber-optic cable to an SFP module:

Class 1 laser product. Statement 1008

Warning

Do not remove the rubber plugs from the SFP module port or the rubber caps from the fiber-optic cable

Caution

until you are ready to connect the cable. The plugs and caps protect the SFP module ports and cables from

contamination and ambient light.

Step 1

Remove the rubber plugs from the module port and fiber-optic cable, and store them for future use.

Step 2

Insert one end of the fiber-optic cable into the SFP module port.

Step 3

Insert the other cable end into a fiber-optic connector on a target device.

Step 4

Observe the port status LED.

The LED turns green when the chassis and the target device have an established link.

If the LED is off, the target device might not be turned on, there might be a cable problem, or there might be problem

with the adapter installed in the target device.

Step 5

If necessary, reconfigure and restart the chassis or target device.