Low Battery Indicator - Hearth and Home Technologies SMART-STAT Installation And Operating Instructions Manual

-
+
Figure 6. Setting Button/Child Proof Lockout
Setting F / C Scale
º º
The factory setting for temperature is degrees Fahrenheit (ºF).
To change this setting to degrees Centigrade (ºC):
1. Remove the battery cover on the back of the transmit-
ter and locate the "setting button" at the top center of
battery compartment (see Figure 6).
2. Push setting button and ºF will begin fl ashing on the
LCD screen (see Figure 5, Location #4).
3. Push the DOWN button on the transmitter to change ºF
to ºC.
4. Push "setting button" on transmitter and Centigrade (ºC)
degree readings will display on LCD screen.
5. Repeat this process to change back to Fahrenheit (ºF)
reading, this time pushing the UP button. NOTE: LCD
screen will return to normal state if setting button is not
pushed within 15 seconds.
Setting Desired Room Temperature -
Thermo Operations
This remote control system can be thermostatically con-
trolled when the transmitter is in the THERMO mode.
(THERMO must be displayed on the screen). The transmit-
ter will "sense" the room temperature every two minutes
automatically turning the fi replace ON or OFF thermostati-
cally. To set the desired room temperature:
1. Press the MODE button to place the transmitter into
THERMO mode. THERMO ON or OFF will display.
Hearth & Home Technologies • SMART-STAT Remote Control Instructions • 100-906 Rev. J • 2/17
SETTING
BUTTON
2. Press the UP or DOWN button to select the desired
room temperature. The highest SET temperature is 99º
F (37º C). The lowest SET temperature is 45º F (7º C).
NOTE: To prevent repeated thermo-cycling of the gas
appliance, the sensing unit in the transmitter will only ac-
tivate the remote receiver when the temperature change
exceeds 1 F (1/2 C) above or below the SET (desired)
º º
temperature.
When the transmitter is in the THERMO mode, it should be
kept away from direct sources of heat such as fi replaces,
incandescent lighting and direct sunlight. Leaving the trans-
mitter in direct sunlight, for example, will cause it to read
the room temperature higher than it actually is.
Setting the Countdown Timer
This remote control system can operate with a built-in
countdown timer when the transmitter is in the ON or
THERMO modes (THERMO or ON must be displayed on
the LCD screen).
1. Press and release the TIMER/TIME button on the trans-
mitter. The word TIMER and 0:15 fl ash on the screen
(see Figure 5, Location #2).
2. Press the UP and DOWN button to begin advancing
through each of the countdown time options. Available
countdown times are 15 min, 30 min, 45 min, 1 hour,
1 hr 30 min, and each additional half hour up to nine
hours.
3. To set the TIMER, press the SET button on the transmit-
ter. If the system is ON, it will remain on until the "time"
has expired. If the system is in the THERMO mode, it
will cycle on and off as the room temperature requires
until the "time" has expired.
NOTE: When the timer is used in the THERMO mode,
the THERMO operation will discontinue when the "time"
has expired.
Low/Battery Indicator
An "X" outlined by a battery on the right side of the LCD
screen will appear when battery power has dropped sig-
nifi cantly. At this time, approximately two weeks of battery
power remains.
5