Autopilot Operation; Autopilot Control Card - Raymarine Marine RADAR Operating Manual

Autopilot Operation

Using the Autopilot controls
Card 23
How do I access Auto and Standby from my E-Series?
Enabling the Autopilot from set up:
Enabling and engaging the autopilot
To allow the E-Series to control autopilot functions, you need to
enable autopilot control on the display unit. With autopilot
control enabled, the unit lets you engage the autopilot whenever
it has a target waypoint. You can see information for the target
waypoint on the Pilot Control pop-up. The default autopilot
setting is disabled.
What are the Autopilot symbols?
Wind Vane Power Steer
mode
mode
How do I engage and disengage the Autopilot in normal operation?
When the autopilot is enabled, the E-Series
prompts you to engage the autopilot
whenever you initiate a GOTO or FOLLOW
ROUTE.
Select GOTO or FOLLOW ROUTE to display
the Engage Pilot screen.
Select ENGAGE PILOT to display the Pilot
Control screen.
NOTE:
If you press OK, CANCEL or the page times
out without engaging the autopilot, you
go back to the navigation screen with the
autopilot disengaged.
How do I disengage the Autopilot in an emergency?
You can choose to disengage the pilot quickly if required by pressing the Power key
Select 'AUTOPILOT STANDBY' to put the
pilot in the autopilot into standby mode
and take control of the helm manually
?
More information...
Pilot Alarm No Pilot
mode connected
FIND
SHIP CURSOR
AUTO
See Autopilot control chapter of the Reference Manual.
To enable autopilot control on the
E-Series display:
Press the MENU button to open
the Setup Menu.
Select System Setup > System
Integration > Autopilot Control >
Enabled.
Press the OK button.
Auto Track
mode mode
NAVIGATION
GOTO AIS OPTIONS
FOLLOW ROUTE
GOTO WAYPOINT
GOTO CURSOR
OPTIONS
OPTIONS
ENGAGE PILOT
TRACK
Standby
mode
PRESENTATION
OPTIONS
STANDBY
AUTOPILOT
STANDBY