Table of Contents
Advertisement
Chapter 4: General Operations
Chapter 4: General Operations
4.1 Turning the Power ON and OFF
Turn the PWR/VOL knob clockwise until it clicks.
When the unit powers up in Normal mode it:
1. Beeps, illuminates the backlight at full brightness, and displays all seg-
ments and indicators for 2 seconds.
2. Displays the software version number on the dot matrix display.
3. Recalls the last CH number, TX power settings and operation mode.
If no last-used setting data exists, goes to CH 16 and high TX Power.
When GPS Data is available, extended position data is also displayed with
the offset time on the dot matrix display. This information will be displayed
when display option for the position and time is enabled on the Menu. See
Section 6.5.
To turn the unit OFF, rotate the Volume knob completely counter clockwise
until it clicks.
4.2 Setting the Volume
Adjust the PWR/VOL knob to control the loudspeaker volume level. Turn
clockwise to increase the volume; counter clockwise to decrease the volume.
Note: Key press beep volume is also controlled by the VOL level.
4.3 Setting the Squelch
The Squelch circuit sets the threshold for cutting off the receiver when the
signal is too weak for reception of anything but noise.
To properly set the squelch, rotate the SQ knob counter clockwise until audio
is heard. Then rotate clockwise until background noise disappears.
4.4 Setting the Power Output
The choice of power output is dependent upon the distance of transmission
and transmitting conditions. International Regulations state you must use the
minimum power possible for satisfactory communication.
17
Hide quick links:
Advertisement
Table of Contents
