On-Vehicle Service; Wheel Bearing Axial Play Check; Hub Bolt Replacement - Mitsubishi EVO VIII 260 Service Manual

26-6

WHEEL BEARING AXIAL PLAY CHECK

CAUTION
!
During maintenance, take care not to contact the
parts or tools to the caliper because the paint of
caliper will be scratched.
1. Remove the caliper assembly and suspend it with
a wire.
2. Remove the brake disc from the front hub.
3. Attach a dial gauge as shown in the illustration,
and then measure the axial play while moving the
hub in the axial direction.
Limit: 0.05 mm
4. If axial play exceeds the limit, disassemble the
front hub assembly and check the parts.
5. Install the brake disc, caliper assembly and
tighten the caliper assembly mounting bolts to the
specified torque 108 ± 10 N⋅m.

HUB BOLT REPLACEMENT

CAUTION
!
During maintenance, take care not to contact the
parts or tools to the caliper because the paint of
caliper will be scratched.
1. Remove the caliper assembly and suspend it with
wire so that it does not fall.
FRONT AXLE

ON-VEHICLE SERVICE

ON-VEHICLE SERVICE
2. Remove the brake disc.
M1261000900268
3. Use the following special tools to remove the hub
• End yoke holder (MB990767)
• Hub bolt remover (MB991618)
AC102438AD
4. Install the plain washer to the new hub bolt, and
5. Install the brake disc, caliper assembly and
M1261001000332
MB991618
bolts.
Plain
washer
install the bolt with a nut.
tighten the caliper assembly mounting bolts to the
specified torque 108 ± 10 N⋅m.
MB990767
AC102439 AC
MB990767
AC102440 AC