Removing and Replacing Cards from the Chassis
Step 2
Figure 7-36 Removing a Card from the Switch Fabric and Alarm Card Cage
Step 3
Step 4
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
7-66
Remove the card (a CSC in this example):
Pivot the ejector levers to unseat the card from the backplane connector.
a.
Grasp the card by its metal card carrier and slide the card out of the
b.
slot
(Figure
7-36).
Place the card directly into an antistatic bag or other ESD-preventive
–
container.
To install the card, reverse the procedure in Step 2.
Close the air filter door and tighten the captive screws.
Chapter 7
Maintaining the Router
OL-11496-01