Step 6, Rol! Range Into Position - GE ZGP484NG Installation Instructions Manual

Installation
IIII I II
STEP 5 CONNECT ELECTRICAL
(Cont.)
A. Usage Situations where Appliance Power Cord
will be Disconnected Infrequently.
An adapter may be used only on a 1S-amp circuit.
Do not use an adapter on a 20-amp circuit. Where
local codes permit, a TEMPORARY CONNECTION
may be made to a properly grounded two-prong
wall receptacle by the use of a UUlisted adapter,
available at most hardware stores. The larger slot in
the adapter must be aligned with the larger slot in
the wall receptacle to provide proper polarity in the
connection of the power cord.
Temporary Hethod
[Adapter plugs not permitted in Canadal
Align large prongs/slots
Ensure proper
ground and firm
connection before
use
ACAUTION:
Attaching the adopter ground
terminal to the wall receptacle cover screw does not
ground the appliance unless the cover screw is metal,
and not insulated, and the walJ receptacle is grounded
through the house wiring. The customer should have
the circuit checked by a qualified electrician to make
sure the receptacle is property grounded.
When disconnecting the power cord from the
adapter, always hold the adapter with one hand.
If this is not done, the adapter ground terminal is
very likely to break with repeated use. Should this
happen, DO NOT USE the appliance until a proper
ground has again been established.
STEP 6
i
ROLL RANGE INTO POSITION
&WARNING
The Anti-Tip Bracket must be properly installed to
prevent tipping of the range. Failure to do so can
cause serious damage or injury.
• Check to be sure the appliance runners are
beneath the wheels.
. The range is shipped with the wheels in the down
position. Carefully roll the range into position,
being careful not to entangle or pinch the power
cord and flexible gas tubing.
° Remove the runners beneath the range.
Be sure Anti-Tip
Bracket is engaged
with the brace on
the range.
14