Just Rec. Function; Notes On Timer Recording - Sanyo VHR-830 Instruction Manual

JUST REC. function
Notes on timer recording
During a timer recording, the VCR will
automatically calculate the remaining tape
duration and, if necessary, will switch the
recording speed from SP (standard play) to
LP (long play), so the programme can be
recorded entirely, without reaching the end of
the tape before recording is completed.
k d
Desired programme length is
210 minutes
Notes:
The (~) indicator will flash if no video
cassette is loaded when going into timer
stand-by mode.
The (g) indicator will flash and the video
cassette is ejected if a video cassette with
no erasure-prevention tab is loaded.
Daily recording starting on a Saturday or
Sunday is not possible.
Even if a timer recording has been preset,
the VCR can be used as usual up to the
programmed start time. When finished
using the VCR, do not forget to return it to
timer recording stand-by mode.
This feature is not available during Quick
Start Recording, and will not work properly
on tapes longer than E-240 or on tapes
shorter than E-1 80.
If two or more timer recordings are
programmed, all the programmes may not
fit on a single tape. In that case, make sure
the JUST REC. mode is not set, and select
the recording speed manually.
There may be some interference in the
image where the speed has been switched.
Types of cassette tapes compatible with the
JUST REC. timer recording mode and
recording durations.
!
Mode
Cassette type
SP LP
E-1 80 180 min. 360 min.
E-240 240 min. 480 min.
Programme priority
If several timer recordings have overlapping
recording time, the recording with the earliest
start time will be recorded first, until the end.
19:00 20:00 21:00
22:00
23:00
1 I 1
,
1
&
These portionswill not be recorded