Just Rec. Function; Notes On Timer Recording - Sanyo VHR-890 Instruction Manual

19
1
ii
ON-SCREEN TIMER RECORDING PROGRAMMING
JUST REC. function
During a timer recording, the VCR will
automatically calculate the remaining tape
duration and, if necessary, will switch the
recording speed from SP (standard play) to
LP (long play), so the programme can be
recorded entirely, without reaching the end of
the tape before recording is completed.
Desired programme length is
210 minutes
Notes:
This feature is not available during Quick
Start Recording, and will not work properly
on tapes longer than E-240 or on tapes
shorter than E-1 80.
If two or more timer recordings are
programmed, all the programmed may not
fit on a single tape. In that case, make sure
the JUST REC. mode is not set, and select
the recording speed manually.
There may be some interference in the
image where the speed has been switched.
Types of cassette tapes compatible with the
JUST REC. timer recording mode and
recording durations.
'a-'e'yl'~
E-1 80 I 180 min. I 360 min.
Notes on timer recording
The (H) indicator will flash if no video
cassette is loaded when going into timer
stand-by mode.
The (~) indicator will flash and the video
cassette is ejected if a video cassette with
no erasure-prevention tab is loaded.
~
Daily recording starting on a Saturday or
Sunday is not possible.
[
Even if a timer recording has been preset,
f
the VCR can be used as usual up to the
programmed start time. When finished
using the VCR, do not forget to return it to
:
timer recording stand-by mode.
[
Programme priority
;
If several timer recordings have overlapping
recording time, the recording with the earliest
~
start time will be recorded first, until the end.
1900 20:00 21:00 22:00 23:00
, 1 I r r
LKY2!Yv
-
These portionswill not be recorded
E-240 I 240 min. I
480 min.
,