Fips - Uniden Mystic Operating Manual

Mystic OMc.book Page 41 Wednesday, August 13, 2003 5:26 PM
you want to store by pressing p or q, and then press and hold [SCAN/
MEMORY] for 2 seconds. The channel is stored in Memory Scan and
MEMORY appears on the LCD display.
To cancel the channel in Memory, press and hold [SCAN/MEMORY] for 2
seconds and the MEMORY icon disappears.
Note: The Memory channel can be set independently in 3 regional
modes (USA, INT, and CAN). You cannot use this feature in
WX mode or for channel 70.

FIPS

The 6-digit Federal Information Processing System (FIPS) code
established by the National Weather Service (NWS) identifies geographic
areas in the United States. Programming FIPS codes are necessary to
receive SAME alerts about weather occurring in a particular area. To
obtain the FIPS code for a particular area contact the NWS toll free at 1-
888-NWR-SAME (1-888-697-7263).
Or visit their website: http://www.nws.noaa.gov/nwr/indexnw.htm.
A list of event codes are located on page 70.
To set FIPS code
1.Press ENTER for 2 seconds.
2.Press ENTER at VHF Menu, the VHF menu appears.
3.Press ENTER.
1.Press ENTER for 2 seconds.
2.Press ENTER at VHF Menu, the VHF menu appears.
3.Press ENTER at FIPS.
4.Press ENTER at NEW, the following screen appears.
5.You can now enter the new FIPS code. Press s to increase and press t
to decrease. The number will be entered when ENTER is pressed, and
the blinking digit moves to the right. When you finished entering the last
digit, the following confirmation screen appears.
6.Press ENTER and the MYSTIC returns to the following screen
EDIT
If you select a number to EDIT.
41