Uniden Mystic Operating Manual page 26

Mystic OMc.book Page 24 Wednesday, August 13, 2003 5:26 PM
If the called radio has been set to Standby Mode, the following
screen appears.
Group Call
1. Select an open (unused) working Channel.
2. Press [CALL/LIGHT].
3. At the D S C M e n u , use p and q to select G r o u p C a l l.
Press [ENTER].
4. The Group MMSI code will appear.
5. Press [ENTER]. You will see the A t t e n t i o n screen. Use t or u to
select Y e s and press [ENTER] to make the call. Or, select N o and
press [ENTER] to cancel the call.
6. After you press [ENTER], the Mystic returns to the Channel
Display screen.
All Ships
1. Select an open (unused) working Channel.
2. Press [CALL/LIGHT].
3. At the D S C M e n u , use p and q to select A l l S h i p s .
Press [ENTER].
4. At the A l l S h i p s C a l l menu, use p and q to select U r g e n c y ,
S a f e t y ,or R o u t i n e .
5. Press [ENTER]. You will see the A t t e n t i o n screen. Use t or u to
select Y e s and press [ENTER] to make the call. Or, select N o and
press [ENTER] to cancel the call.
Note: R O U T I N E calls tune to the previously selected channel.
When sending either an U R G E N C Y or S A F E T Y message, all
radios will automatically move to Channel 70 until all of the
data is received.
After selecting U R G E N C Y or S A F E T Y ALL SHIPS call is
transmitted, the MYSTIC will switch to Channel 16. You
should wait a few minutes before transmitting the ALL SHIPS
call information.
Position Request
This radio has the ability to request the position of an individual vessel
that is registered in the DIRECTORY.
1. Press [CALL/LIGHT].
24