Device List And Connection; Review The Device List; Connect/Disconnect An Active Device - AT&T TL96273 User Manual

Bluetooth
Bluetooth setup

Device list and connection

Up to 4 devices can be paired to the telephone base. All paired devices are
shown on the device list. To use a paired device, it must be in an active slot
(CELL 1 or CELL 2) on the device list and connected. Two Bluetooth cell
phones can be on a call at a time. While you are on a cell line call, you can
also use a Bluetooth headset to make or answer a home line call.
Once you have paired a device with the telephone base, you do not need
to repeat the pairing procedure again unless you delete the device from the
device list.
NOTE: When connecting a Bluetooth device to the device list, all connected devices will be
temporarily disconnected until the procedure is complete. It may take up to 2 minutes to
reconnect.

Review the device list

1. Press MENU
2. Press CID or
3. Press CID or

Connect/disconnect an active device

While in the device list menu, you may connect or
disconnect your active device.
1. Press MENU
2. Press CID or
press SELECT.
3. Press CID or
SELECT .
4. Press CID or
press OPTION
Press CID or
5.
(whichever is applicable), then press
telephone base displays Device connected/Device
disconnected. You hear a confirmation tone.
NOTE: When your active device is connected, you are prompted to
select Disconnect. When your active device is disconnected, you are
prompted to select Connect.
on the telephone base in idle mode.
DIR to highlight Bluetooth, then press
DIR to highlight Device list, then press
on the telephone base in idle mode.
DIR to highlight Bluetooth, then
DIR to highlight Device list, then press
DIR to highlight a device, then
.
DIR to highlight Connect/Disconnect
SELECT . The
18
SELECT .
SELECT .
Directory
Cal ler ID log
Intercom
Bluetooth
BACK SELECT
BLUETOOTH
Add device
Device list
Download dir
BACK SELECT
DEVICE LIST
D1:Headset A
D2:Cel l Phone A
Cel l Phone B
BACK OPTION
HEADSET A
Connect
Remove
Rename
BACK SELECT