Sony XAV-601BT Owner's Record page 62

G:\#sagyou\Sony\0117\4419667111\4419667111XAV601BTU\01GB_XAV601BT\01
US02CD-U.fm
00US+00COV-U.book Page 62 Tuesday, January 17, 2012 6:08 PM
The display disappears from/does not appear
on the monitor.
• The dimmer is set to "ON" (page 50).
• The display disappears if you press and hold
(SOURCE/OFF).
t Press (SOURCE/OFF) on the unit until the
display appears.
• "M.OFF" is set to on and the Monitor Off function is
activated (page 10).
t Touch anywhere on the display to turn the display
back on.
The display does not respond to your touch
correctly.
• Touch one part of the display at a time. If two or more
parts are touched simultaneously, the display will not
operate correctly.
• Calibrate the touch panel of the display (page 43).
The Auto Off function does not operate.
The unit is turned on. The Auto Off function activates
after turning off the unit.
t Exit the source.
Operation of the remote commander is not
possible.
If the Monitor Off function is activated (no lighting),
operation of the remote commander is not possible
(page 10).
The menu items cannot be selected.
Unavailable menu items are displayed in gray.
AUX cannot be selected as the source.
All AUX input settings are set to "OFF."
t Set "AUX1 Input"/"AUX2 Input" to "Video" or
"Audio" (page 53).
The monitor angle cannot be adjusted.
The monitor was opened while the unit was being
reset.
t Be sure to close the front panel before you reset the
unit.
Radio reception
The stations cannot be received.
The sound is hampered by noises.
The connection is not correct.
t Connect an REM OUT lead (blue/white striped)
or accessory power supply lead (red) to the power
supply lead of a car's antenna (aerial) booster
(only when your car has built-in radio antenna
(aerial) in the rear/side glass).
t Check the connection of the car antenna (aerial).
t If the auto antenna (aerial) will not extend, check
the connection of the power antenna (aerial)
control lead.
Preset tuning is not possible.
• Store the correct frequency in the memory.
• The broadcast signal is too weak.
Automatic tuning is not possible.
The broadcast signal is too weak.
t Perform manual tuning.
62
RDS
PTY displays "None."
• The current station is not an RDS station.
• RDS data has not been received.
• The station does not specify the program type.
Picture
There is no picture/picture noise occurs.
• A connection has not been made correctly.
• Check the connection to the connected equipment,
and set the input selector of the equipment to the
source corresponding to this unit.
• The disc is defective or dirty.
• Installation is not correct.
t Install the unit at an angle of less than 45° in a
sturdy part of the car.
• The parking cord (light green) is not connected to the
parking brake switch cord, or the parking brake is not
applied.
The picture does not fit in the screen.
The aspect ratio is fixed on the DVD.
There is no picture/picture noise occurs in the
rear monitor.
• A source/mode which is not connected is selected. If
there is no input, no picture appears in the rear
monitor.
• The color system setting is incorrect.
t Set the color system to "PAL" or "NTSC"
according to the connected monitor (page 47).
• The picture of the rear view camera is displayed on
this unit.
t No picture appears in the rear monitor if the
picture of the rear view camera is displayed on
this unit.
masterpage:Left
XAV-601BT
4-419-667-11(1)