Sealants And Lubricants Table; Regarding Submission Of Parts For Epa Exhaust Gas Regulation - Mitsubishi S6S Service Manual

MAINTENANCE STANDARDS
3.

Sealants and Lubricants Table

Apply to
Oil pan
Rear bearing cap seat on crankcase
Side seals
Cylinder head coolant hole plug
Crankcase coolant hole plug
Crankcase oil hole plug
Return oil hole blind plug or pipe
of crankcase
Crankshaft threads
ThreeBond 1207C/1212/1211; Silicon liquid gasket Oil resistant/Formed-in-place/Low viscosity
ThreeBond 13860D;
4.

Regarding Submission of Parts for EPA Exhaust Gas Regulation

The following parts have been submitted in accordance with EPA emission regulation.
(1) Fuel injection assembly
(2) Fuel injection nozzle
(3) Turbocharger assembly
(4) Other related parts (including designated fuel and lubricant)
When replacing parts, make sure to use OEM designated parts. If OEM parts are not used, the
exhaust emission's warranty will be voided. New parts may be updated due to improvement. Fuel
and Exhaust system repairs should only be conducted by an authorized Mitsubishi forklift dealer.
Tampering or adjusting the fuel system components will void the warranty and could be in
violation of the EPA regulations. The fuel injection pump must be replaced as an assembly.
Mating part
Crankcase
Rear bearing cap
Crankcase rear
bearing cap
Cylinder head
Crankcase
Crankcase
Crankcase
Crankshaft pulley
nut
Anaerobic adhesive
CAUTION
Sealant or Lubricant
ThreeBond 1207C
ThreeBond 1212
ThreeBond 1211
ThreeBond 1386D
ThreeBond 1386D
ThreeBond 1386D
ThreeBond 1386D
ThreeBond 1212
2-8
How to Use
Apply to seal.
Apply to corners before
installing cap.
Apply to side seals.
Apply to plug hole.
Apply to plug hole.
Apply to plug hole.
Apply to blind plug or pipe.
Apply to crankshaft thread
before tightening nut.