Setup - Ramsey Electronics URC1 Owner's Manual

Setting up the URC1:
These are some general ideas for setting up the URC1 for either a multiple
user remote control, or a protected mode of operation. We will start from very
first power up, all the way to leaving the URC1 to do it's stuff. If you are
interested in more details about the codes used refer to the the section on
URC1 command codes.
1. Power up and test the URC1 as instructed in the initial testing section of
the manual.
2. Hook up any of the peripherals that you may want to control such as
lamps, radios, alarm systems etc. Make sure commons on circuits are
connected properly to the URC1.
3. Enter in as a master user using *6. Use your tone generator to set the
devices you want to exclude from the user, such as the alarm system. Use
the control codes in the rear of the manual for instructions.
4. Set your initial values, check everything out for proper operation.
5. Set the user password, which is limited to three characters, and then the
master password which is limited to four. Make sure and write these down. If
you forget them, you have to disconnect the power and remove the battery to
reset them.
6. Press *3 to tell the URC-1 that you are finished. At this point the URC-1
will blank it's display, and wait for the password of a user or master to access
it again. If a user is to access it, the items that you disabled by excluding
them cannot be changed. Only the master can change them now.
From confirm out
From CON1 pin 33
URC1 • 19