Setting Parameters Via Hw Config - Siemens SIMATIC SM 335 Manual

3.2

Setting parameters via HW Config

Measuring Range Module
You must plug in the measuring range module into the side of the SM 335.
You can learn how to do this in Reference Manual SIMATIC Programmable Logic
Controller, S7-300 Module Data. Section 1.4 describes the measuring ranges to be
set.
HW Config
Certain features of the SM 335 (e. g., cycle time, A/D conversion) are explained in
HW Config, Parameter Assignment of STEP 7.
The measuring range modules in the module must also be set to the necessary
settings if required (see Section 1.4).
SM 335 – High-Speed Analog Input/Output Module for the SIMATIC S7-300
6ES7 335-7HG00-8BA1
Data Exchange with the SM 335
3-11