Using Two Or More Similar Devices - Radio Shack 7-in-1 Remote Control with Lighted Keypad Owner's Manual

15-1924.fm Page 10 Monday, July 19, 1999 12:50 PM
5. Point the 7-in-1 Remote Control at your
device and press
for some cable boxes). Your
CHANNEL + (On)
device should turn off (or on, if it was off).
If the remote does not operate your device,
try the other codes listed in "Manufacturers'
Codes" on Page 23 for your brand of TV,
VCR, cable converter, or other device.
6. Repeat Steps 2–5 for additional devices.

Using Two or More Similar Devices

If you have two or more similar devices (two
VCRs for example) and you have already pro-
grammed the 7-in-1 to control one of the devices
using that device key, you can program the
and device keys or an unused device key to
AUX2
control the additional device.
Follow these steps to program
1. Repeat Step 1 and 2 under "Setting Up Your
7-in-1" on Page 9.
2. Press or
AUX1 AUX2
3. If you are replacing a CD's remote control,
skip to Step 4. Otherwise, press the device
key for the type of remote you are replacing
( , , , , Plug 'n Power, or
VCR CBL TV CD
Note: If you do not press a device key within
about 15 seconds, the red light flashes for
about 3 seconds then turns off. Start again
from Step 1.
4. Repeat Steps 4–6 under "Setting Up Your 7-
in-1" on Page 9.
To program an unused device key to control an
additional device, choose an unused device key
that controls a similar type of device (see "Device
Types" on Page 8), then program it using the
steps in "Setting Up Your 7-in-1" on Page 9.
Need help? Call 1-800-989-4706
10
(or
POWER (All Lts On)
AUX1
or .
AUX1 AUX2
.
.
SAT