Using The Remote Control Unit - Sanyo KS2432 Instruction Manual

How to Install Batteries
How to Use the Remote
Control Unit
Remote Control Unit
Installation Position
OI-201-11EG
Downloaded from www.Manualslib.com

Using the Remote Control Unit

ACL button
The batteries last about six months, depending on how much you use
•
NOTE
the remote control unit. Replace the batteries when the remote control
unit's display fails to light, or when the remote control cannot be used
to change the air conditioner's settings.
Use two fresh leak-proof type-AAA alkaline batteries.
•
In replacing batteries, follow the instructions as mentioned in the
•
sub-section ''How to Install Batteries''.
If you do not use the remote control unit more than 1 month, take out
•
the batteries.
When using the remote control unit, always point the unit's transmitter
head directly at the air conditioner's receiver.
Air conditioner
(Indoor unit)
Remote control
unit
The remote control unit may be operated either from a non-fixed position
or from a wall-mounted position. To ensure that the air conditioner operates
correctly, DO NOT install the remote control unit in the following places:
DO NOT In direct sunlight
•
Behind a curtain or other places where it is covered
•
More than 26 ft. away from the air conditioner
•
In the path of the air conditioner's airstream
•
Where it may become extremely hot or cold
•
Where it may be subject to electrical or magnetic noise
•
Where there is an obstacle between the remote control unit and air
•
conditioner (since a check signal is sent from the remote control unit
every 3 minutes)
manuals search engine
1. Slide the cover in the direction
indicated by the arrow and remove
it.
2. Install two AAA alkaline batteries.
Make sure the batteries point in
the direction marked in the battery
compartment.
3. Use a thin object such as the tip of
a pen to press the ACL button.
Receiver
(Transmitter head)
11