Electrical Connections On The Single Phase Outdoor Unit Side - Fujitsu Waterstage WOYG112LCTA Maintenance Document

Air to Water Heat Pump (Split integrated DHW type)
5 .3 Electrical connections
on the single phase outdoor unit side
Access to the connection terminals:
- Remove the front panel. Remove the screws and the
front panel.
figure 34 - Access to sinlge phase outdoor unit's
terminal block
1
Cover plate
Insulation (seal)
Secure cables so that they are not in
contact with pipes and valves.
- 34 -
Remove the screws
and push downwards
Terminal
block
Service panel
Valve cover
Hook (4places)
2
Power supply
cable and
connection cable
CAUTION
figure 36 - Finalisation of connection to single phase outdoor unit
- Make the connections in accordance with the diagram
figure 35 et figure 44, page 39
Terminal block
Interconnection between
the outdoor unit and
the hydraulic unit
figure 35 - Connections to sinlge phase outdoor unit's
- Use cable clamps to prevent the conductors from
being disconnected accidentally.
- Use the mounting plate to hold the cables against the
insulating plate
Cable clip
Installation and operating manual "1768 - EN"
terminal block
(figure 36)
3
Cover plate
Cables
Release
Gas valve
Power
supply