Modification of this product may result in property damage. Dometic recommends that a qualified marine or RV technician or electrician install or service this product . Equipment damage, injury to personnel or death could result from improper installation .
. To prevent this pos- sibility, Dometic recommends using the “full” tank shut-down relay in the toilet’s electronic control module . The “full” signal from the holding tank can be generated by an optional...
Discharge loop outlet 4-wire cable to toilet macerator Discharge adapter fitting pump and water valve Discharge hose fitting Cable for Dometic DFT flush switch or DSS status panel (RJ45/ethernet) Macerator pump Cable to toilet’s electronic flush Water valve handle (for flush handle model) Water line - 0 .5 in .
Raw water system layout - marine application (additional components required) Dometic macerator toilets can flush on seawater but require a separate pump for this purpose . The pump is activated by the signal from the toilet’s electronic control module that would operate the integral water valve in a fresh water system .
Page 8
. Be sure module and wires cannot get wet . 5 . Use Dometic wall switch template to mark location of fastener and access holes . Drill 1 in . (25 mm) hole, then fasten panel bracket to wall (fig .
Page 9
Dometic 8700 Series MasterFlush Toilet Installation 11 . Loosen band clamp on discharge loop outlet and remove discharge adapter fitting/hose fitting assembly (fig . 12 . Lubricate discharge fitting assembly and inside end of discharge hose with liquid dishwashing soap . Push discharge fitting assembly into discharge hose and connect with two hose clamps .
Page 10
2 . Plan electronic control module and status panel locations so that electrical connections can be made with cables provided . Be sure module and wires cannot get wet . 3 . Use Dometic wall switch template to mark location of fastener and access holes for DSS status panel (fig .
Always use stranded copper wire (preferably tinned) . • Always use crimp-type wire connections . Do not use wire nuts (they corrode) . When installing a Dometic macerator toilet in a recreation vehicle, please use the following wiring information . WIRE SIZING CHART Wire size per length of run* 0-15 ft.
8:00 a .m . to 5:00 p .m . (ET) parts needs . They carry a complete inventory Monday through Friday . for the Dometic product line . Telephone: 1 800-321-9886 U .S .A . and Canada...