Hotpoint WDL756PUK Service Information page 12

Indesit Company
8. Remove 2 x 10 mm nuts securing shock absorbers to base of cabinet.
9. Remove tank/pump hose.
10. Carefully slide the outer drum clear protecting any wiring.
M Front Concrete Weight
1. Remove the drum assembly (N).
2. Remove the weight fixing bolts and lift clear.
N Motor
1. Remove the 6 screws securing back panel (B) to gain access to the belt.
Release the belt from the motor pulley.
2. Remove the 2 bolts securing the motor. The motor should be supported when removing the last bolt.
3. Carefully lift the motor clear.
O Pump
1. Remove the plinth.
2. Using suitable protection, tilt the machine backwards and support.
3. Remove the pump fixing screws and disconnect the hoses and wiring.
P Power Module
1. Remove the back panel (B).
2. Remove the 2 screws securing the module support to the cabinet.
3. Disconnect the wiring - note the plug positions.
4. Lift the module and support clear.
Q Door Seal Retainer to Outer Case
1. The door seal is fixed to the cabinet front panel by a wire clamp and a small spring.
2. The spring is usually at the bottom of the door.
3. Carefully attached a small screwdriver to one of the ears of the spring.
By stretching the spring the wire band can be removed.
R Shock Absorbers
1. Using suitable protection lean the appliance onto one side.
2. Remove the 10 mm nut securing the shock absorber to the cabinet.
3. Push the shock absorber on the rod until it comes out of the cabinet.
4. Remove shock absorber plastic expansion pegs.
S Drying Heater Box
1. Remove the top cover (A).
2. Remove the back panel (B).
3. Taking note of the wiring connections, disconnect the wiring to the dry heater, thermistor, cut-out
and fan.
4. Remove the condensing hose from the condenser.
5. Remove the plastic tie fixing the door seal to the dryer box outlet.
NOTE: A new plastic tie will be required when refitting.
6. Remove 4 screws securing the Heater Box to the outer drum.
7. Lift the dryer box clear.
Service Manual UK
12 of 33
English