Table of Contents
Advertisement
43-1245.fm Page 30 Wednesday, August 18, 1999 9:51 AM
BASIC PROGRAMMING STEPS
The following sections provide you with the basic instructions
for programming the AFX-300's special features from a local
(extension) or remote touch-tone phone.
Notes:
• You must correctly enter a 2-digit access code each time
you program the AFX-300. The AFX-300's access code
is preset to 99. To change the code or reset the AFX-300
to the default code, see "Changing the Access Code" on
Page 34.
• You can only enter one program command per call from
a remote phone or from an extension on the same line.
• Do not set the AFX-300 so both its
are turned off at the same time. If you do, you might not
be able to turn on either one remotely. You must use a
touch-tone phone on the same line as your AFX-300 to
turn on either jack (see "Programming from an Extension
Phone" on Page 27).
• If you connected a programmable TAD to the same line
as the AFX-300, the TAD might respond to programming
commands intended for the AFX-300. If you are using an
extension phone, disconnect or turn off the TAD during
programming, then reconnect it when you finish. If you
are using a remote phone, turn off the
you program the other settings (see "Turn On/Off the
TAD Jack" on Page 37).
30
and
jacks
TAD
FAX
jack before
TAD
Advertisement
Table of Contents
