Cisco Catalyst 3850 Deployment Manual page 11

Enter the boot manual command, along with the switch name or number:
Switch(config)# boot manual switch 1
Switch(config)#^Z
Switch#wr mem
*Mar 17 22:34:15.142: %SYS-5-CONFIG_I: Configured from console by console
Building configuration...
Compressed configuration from 8910 bytes to 3178 bytes[OK]
Switch# reload
This is a sample of the switch display following a manual boot:
Booting...Initializing RAM +++++++@@@@@@@@...++++++++++++++++++++++++++++++++
Base ethernet MAC Address: f8:4f:57:6f:e1:00
Interface GE 0 link down***ERROR: PHY link is down
Initializing Flash...
flashfs[7]: 0 files, 1 directories
flashfs[7]: 0 orphaned files, 0 orphaned directories
flashfs[7]: Total bytes: 6784000
flashfs[7]: Bytes used: 1024
flashfs[7]: Bytes available: 6782976
flashfs[7]: flashfs fsck took 1 seconds....done Initializing Flash.
The system is not configured to boot automatically.
following command will finish loading the operating system
software:
switch:
There is a limited set of commands that are supported at the boot loader command prompt. Enter a question mark
to view the available commands.
Note:
Use the version boot loader command to display the current boot loader version:
switch: ver
CAT3K_CAA Boot Loader (CAT3K_CAA-HBOOT-M) Version 1.3, RELEASE SOFTWARE (P)
Compiled Thu Jun
© 2015 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
boot
Appendix A of this guide shows the complete list of boot loader commands.
6 08:04:54 PDT 2013 by rel
The
Page 11 of 36