Table of Contents
Advertisement
uSing tHe pan arM to MoVe tHe Scope
To pan the scope side to side or up and down, first loosen the side
and/or vertical lock. Then unlock the pan arm by rotating it
counterclockwise and use it to move the scope as desired. To lock
the scope in place, rotate the pan arm clockwise and tighten the
side/vertical locks.
uSing tHe eYecup anD SunSHaDe
If you wear eyeglasses, fold down the rubber eyecup if you have
difficulty seeing the entire image. If the sun is at an angle to the
scope rather than behind you, glare may be a problem, causing
reduced image quality. If so, extend the sunshade out past the end
of the scope.
care
The optics of your spotting scope are treated with special anti-
reflective coatings for increased light transmission. As with any
coated optics, special care must be taken in cleaning the lenses.
Moisten the surface of the lens slightly and wipe dry using a
circular motion starting at the center of the lens. Wipe or brush off
any dirt or dust on the outside of the spotting scope.
caution
Never disassemble your spotting scope. Special tools and
equipment are required for service and irreparable damage can
result from repair attempts by untrained persons. Unauthorized
service may also void the warranty.
caution: DO NOT LOOK AT OR NEAR THE SUN
THROUGH THIS SPOTTING SCOPE, AS SEVERE
DAMAGE TO YOUR EYES MAY RESULT !
OPERATION, CARE and CAUTIONS
3
Advertisement
Table of Contents
