Sending Recalled Data; Sending All Stored Data - Hach DR/820 Instrument Manual

SECTION 6,
continued

6.3.2 Sending Recalled Data

6.3.3 Sending All Stored Data

To transfer recalled data:
1. Remove the instrument cap and slide the DTA onto the
instrument until snug.
2. Make sure the DTA is properly connected to the computer or
printer. (See Section 6.2 RS232 Connections.)
3. Recall the data to be transferred (see Section 5.1 Recalling
Data on page 39).
4. When sample data is displayed, press the
horizontal lines and
transmitted to the DTA.
All data stored in memory may be sent to a printer or computer
via the menu option as follows:
SETUP
1. Remove the instrument cap and slide the DTA onto the
instrument until snug.
2. Make sure the DTA is properly connected to the computer or
printer. (See Section 6.2 RS232 Connections.)
3. Press the
SETUP
4. Scroll, using the down
5. Press the
ENTER
. All stored data is now sent to the DTA. After the data
PRINT
has been successfully sent, the instrument defaults to the last
used program.
Transferred data will include the following information:
•
instrument model number
•
instrument serial number
•
instrument software version
•
date
48
are displayed while the data is
PRINT
key.
key, to the
ARROW
key when the word
ALL
key. Four
PRINT
option.
PRINT
is displayed above