Table of Contents
Advertisement
POWER SOURCE (CONTINUED)
REMOTE BATTERY INSTALLATION
Follow these precautions when using batteries in this device:
1.
Warning–Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type.
2.
Use only the size and type of batteries specified.
3.
Be sure to follow the correct polarity when installing the batteries as indicated
in the Battery Compartment. A reversed battery may cause damage to
the device.
4.
Do not mix different types of batteries together (e.g. Alkaline, Rechargeable
and Carbon-zinc) or old batteries with fresh ones.
5.
If the device is not to be used for a long period of time, remove the batteries
to prevent damage or injury from possible battery leakage.
6.
Do not try to recharge a battery not intended to be recharged; it can overheat
and rupture. (Follow battery manufacturer's directions.)
LINE IN JACK (REAR OF UNIT)
Insert one end of the audio cable (not included) into the LINE OUT jack on your
external audio unit and the other end into the LINE IN jack on the rear of this unit.
To listen to the external audio unit, turn this unit on using the Power button, and
turn on the external unit as well. Repeatedly press the SOURCE button to select
LINE IN mode; "AUX" will appear in the display. The external audio unit's output
sound will be heard through this unit's speakers. If you wish to listen to the iPod
in the iPod compartment, repeatedly press the SOURCE button to select iPod
mode; iPod will appear in the display.
1.
2.
3.
BATTERY PRECAUTIONS
OPTIONAL CONNECTION
Remove the Battery Compartment by
pressing in on the tab and then sliding the
compartment out.
Install a CR2025 battery, by popping it in
through the back of the compartment,
paying attention to the polarity diagram in
the compartment (positive side up).
Replace the Battery Compartment.
8
Hide quick links:
Advertisement
Table of Contents
