Table of Contents
Advertisement
AC ADAPTER CONNECTION
Connect the AC adapter (included) to an AC outlet having 120V, 60Hz AC only.
Plug the small end into the DC jack on the rear of the unit.
CAUTION: Do not touch the AC adapter with wet hands. Fully insert the plug with-
out exposing any part of the blade.
Z
DC 6V
INSERTING BATTERIES
Two AAA size batteries can also be used to power and/or to provide a backup for
the clock and alarm time for this unit as follows:
1. Open the battery door by sliding it towards the bottom of the unit.
2. Insert two (2) "AAA" batteries as shown. Alkaline batteries are recommended
for the longest playing time.
3. Slide the battery door back on.
NOTE: The batteries are used to back-up the clock and alarm time only when the
AC adapter is disconnected or if there is a power failure.
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the
battery compartment. Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline, Rechargeable and
Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to pre-
vent damage or injury from possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and
rupture. (Follow battery manufacturer's directions.)
BACKLIGHT
If the power supply is connected to the DC 6V IN jack, the backlight will always
light on in the display.
INSTALLATION
+
+
BATTERY PRECAUTIONS
6
Hide quick links:
Advertisement
Table of Contents
