Height Of The Needle Bar - Brother LS-1717 Service Manual

Standard
• When the needle is at the right side, the shuttle hook point is aligned with the left side of the needle, the
shuttle hook point lower edge should be 0.8 - 1.2mm above the upper edge of the needle eye.
Adjustment
1. Set the stitch width konb to 5, then lower the needle to its lowest position at the right side of the needle
plate.
2. Loosen the setscrew
3. Move the needle bar
4. Retighten the setscrew

Height of the needle bar

of the needle bar .
up or down to make adjustment.
.
- 8 -