Introduction; Assembly - Siemens SITRANS TH100 Operating Instructions Manual

Introduction

These instructions contain all information required to commission and use the device. It is your
responsibility to read the instructions carefully prior to installation and commissioning. In order
to use the device correctly, first review its principle of operation.
The instructions are aimed at persons mechanically installing the device, connecting it
electronically, configuring the parameters and commissioning it, as well as service and
maintenance engineers.
The following table shows the most important changes in the documentation compared to each
previous edition:
Edition
01
06/2006
02
06/2010
03
04
08/2013
The contents of this manual shall not become part of or modify any prior or existing agreement,
commitment or legal relationship. The sales contract contains all obligations on the part of
Siemens as well as the complete and solely applicable warranty conditions. Any statements
regarding device versions described in the manual do not create new warranties or modify the
existing warranty.
The content reflects the technical status at the time of publishing. Siemens reserves the right
to make technical changes in the course of further development.
Observe the test certification, provisions and laws applicable in your country during connection,
assembly and operation. These include, for example:
● National Electrical Code (NEC - NFPA 70) (USA)
● Canadian Electrical Code (CEC) (Canada)
Further provisions for hazardous area applications are for example:
● IEC 60079-14 (international)
● EN 60079-14 (EC)
SITRANS TH100
Operating Instructions, 09/2013, A5E00331168-04
Remark
First edition
Editorial revision as
regards content
Not released
Editorial revision as
regards content
Firmware identification
nameplate
FW: 01.01.00
FW: 01.01.00
FW: 01.01.00
System integration
TH100: SIPROM T V1.07
TH100: SIPROM T V1.07
TH100: SIPROM T V1.2.3
1
5