Initializing The Scanner - Radio Shack PRO-70 Owner's Manual

20-310.fm Page 50 Wednesday, August 4, 1999 10:49 AM

Initializing the Scanner

Caution: This procedure clears all information you stored
in the scanner's memory. Initialize the scanner only when
you are sure the scanner is not working properly.
1. Turn off the scanner, then turn it on again.
2. Press and hold
CLEAR
3. While holding down
such as a straightened paper clip, into the reset
opening on the side of the scanner and gently press
then release the reset button inside the opening.
4. When the display reappears, release
Note: You must release
otherwise the memory might not clear.
50
.
, insert a pointed object,
CLEAR
.
CLEAR
before releasing
RESET
,
CLEAR