Table of Contents
Advertisement
3-1-2 Procedures to change the Function Setting
This procedure changes to the function settings used to control the indoor unit according to
the installation conditions. Incorrect settings can cause the indoor unit malfunction.
After the power is turned on, perform the "FUNCTION SETTING" according to the installation
conditions using the remote controller.
Settings will not be changed if invalid numbers or setting values are selected.
PREPARATION
Turn on the power.
* By turning on the power indoor units, so make sure the piping air-tight test and
vacuuming have been conducted before turning on the power.
* Also check again to make sure no wiring mistakes were made before turning on the power.
FUNCTION SETTING METHOD (for Wireless remote controller)
Entering the Function Setting Mode
While pressing the
press the
button to enter the function setting mode.
Selecting the Function Number and Setting Value
(1) Press the
and Setting Value.
(There is no necessity for setting remote control signal code. Because
signal code is setting by Fanction Number and Setting Value.)
(2) Press the
(
(Press the
(3) Press the
(Press the
(4) Press the
(
(Press the
(5) Press the
(Indoor unit recognize the setting.)
(6) Press the
/
(Indoor unit run the setting.)
(7) Press the
button to cancel the function setting mode.
(8) After completing the FUNCTION SETTING, be sure to turn of the
power and turn it on again.
After turning off the power, wait 10 seconds or more
before turning on it again.
The FUNCTION SETTING doesn't become effective
if it doesn't do so.
button and
button, and proceed to Fanction Number
) (
) buttons to select the Function Number.
button to switch between the left and right digits.)
button to proceed to Setting Value.
button again to return to the Function Number selection.)
) (
) buttons to select the Setting Value.
button to switch between the left and right digits.)
button. It makes a signal to indoor unit.
button. It makes a signal to indoor unit.
CAUTION
(
) button simultaneously,
03-04
Function
Number
Setting
Value
Advertisement
Table of Contents
Troubleshooting
