Transferring Data (Drive To Sd) - Siemens SIMOTICS S-1FL6 Operating Instructions Manual

Note
You must save the parameter set after setting the parameter set to the default values;
otherwise, the default values will not be saved to drive ROM.
Reference
Saving parameters (RAM to ROM) (Page 124)
6.5.4

Transferring data (drive to SD)

You can save the parameter set from the drive ROM to a micro SD card/SD card with the
BOP. To do this, proceed as follows:
Note
Data transfer between the drive and the SD card is possible only when the drive is in "servo
off" state.
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 09/2016, A5E37208830-002
Basic operator panel (BOP)
6.5 Auxiliary functions
125