Axminster HBS200N Manual page 25

Code: 101807
INTRODUCTION
• Bandsaw Buddy is a unique bandsaw blade
aligning tool. Bandsaw Buddy allows you to check
the alignment of the bandsaw blade to the face of
the fence. Most other checks only require the use
of a combination or engineer's square. Truing the
fence to the blade is tricky. Bandsaw Buddy has two
rare earth magnets which hold it firmly on the blade.
At 250mm long it is easy to spot any discrepancy
and then make necessary adjustments. The magnets
will keep it safely stored on the bandsaw's frame
when not in use.
• A scale on the tip helps set the bandsaw fence
for cutting veneers or thin boards. Holes along the
Buddy's length at 12.5mm intervals allow you to draw
arcs or circles in 25mm steps from 75mm to 400mm,
a useful feature for marking curves or when cutting
bowl blanks. Accurately machined from anodised
aluminium, it also makes a handy straight edge.
KEY FEATURES
• Designed and made in Axminster
• Unique bandsaw blade aligning tool
• Checks the alignment of blade to the face of the fence
• Rare earth magnets hold it firmly on the blade
• 250mm long makes it easy to spot any discrepancy
• Scale on the tip helps set fence for cutting veneers or
thin boards
• Holes for drawing circles in 25mm steps from 75 to
400mm
• Accurately machined from anodised aluminium
UJK Technology Bandsaw Buddy
Marking Gauge
An easy to use circle marking
gauge for bowl blanks from
75mm to 400mm radius in
increments of 25mm.
Thickness Gauge
A convenient and accurate
metric thickness gauge, great
for veneering.
25 25
Accurate Marking
The bandsaw buddy can be
used as a straight edge for
accurate marking.
Perfect Alignment
Rare earth magnets securely
hold the rule to the blade.
This enables you to align your
rip fence and table perfectly
parallel with the blade.
Keep your buddy
on hand
Once you've used your
Bandsaw Buddy the
integrated magnets allow
simple storage on your
bandsaw