Table of Contents
Advertisement
1. HOW TO INSTALL THE UNIT
Fasten the handset fixture to the bottom of the telephone with a screw (3x14, sup-
plied).
Mounting base
(Desktop: Use installation materials,
Bulkhead: Use telephone accessories.)
3. The catch in the receiver cradle functions to hang up the handset. Set the catch
in the upward position. To detach the handset from the hanger, slide the handset
upward.)
4. Set the telephone to the four catches in the mounting base, then slide it toward
you until you hear a click.
5. Attach the "SLIDE" label (supplied) to the handset.
6. Attach the label (16-007-6927-0) for compass
safe distance as shown below.
7. Set the line type of telephone to PB (Push Button) type from DP (Dial Pulse) type
as follows.
1) Remove the plastic sheet and recording sheet.
2) Set #1 DIP switch to ON (PB side).
3) Reattach the plastic sheet and recording sheet.
1-18
Catches
Secure mounting
base with tapping
screws.
Line type
Side tone
Bell off
PB S
ON
OFF
1
2
3
4
DP L
Attach handset
fixture here.
Unfasten this
screw.
Bottom view
Mounting base stopper
Remove plastic sheet and
recording sheet.
Set #1 to ON (PB).
Handset
fixture
Catch
Label (16-007-6927-0)
Advertisement
Table of Contents
