Advertisement
Even if you are not completing installation yourself, it's good to familiarize
yourself with these important steps to ensure proper set-up.
5. Sounds and Vibration
Increased spin speeds on the Duet
washer require a sturdy floor and a
level machine. Reinforcement may be
required for installation on a second
floor or over a basement. The washer
sound and vibration performance will
vary depending upon the design of
the flooring structure.
For improved sound and vibration
performance, consider the following
guidelines:
6. Estimated Time Remaining
Actual washer cycle time may differ
from the "Estimated Time Remaining"
display. The difference is due to the
time required to rebalance the washer
load during spin to attain the highest
spin speed for water extraction.
7. Move the Washer and Dryer Professionally
If you are moving to a new home
and plan to take your Duet
care pair with you, please call
1-800-253-1301 and speak to a
Call 1-800-253-1301 to speak to a Duet
see your Use and Care Guide for complete installation instructions.
After you Buy
• Reinforce the floor where the
®
washer will be located by securing
a sheet of plywood at least 3/4 inch
thick to the floor (cement board
subflooring should improve noise
and vibration performance)
• Place the washer near the corner
of the room
• Place the washer near an external
structural support wall
• Do not place the washer on a floor
with foam support (floating floor)
• Do not place the washer on
carpeting
With the Duet HT
the water heating cycles, the
difference is also partially due to the
time required to heat water.
Duet
fabric care expert. He/she can
®
fabric
recommend a Whirlpool-endorsed
®
installer who will re-install new
shipping bolts and provide
Questions about installation?
®Registered trademark/™ Trademark of Whirlpool, U.S.A. ©2004 Whirlpool Corporation. All rights reserved.
Form # EWPL_MIC_604_021. Printed in the U.S.A. 08/04. www.whirlpool.com.
Normal sounds include:
• During drains and final spin, the
sound level shifts as the water is
removed by the pump
• As the washer ramps up to the
final spin speed, the washer may
experience a shudder – a result of
the high performance suspension
settling as the washer goes into
the high extraction speeds
washer, during
The time does not adjust up or down
®
when these activities occur. Instead,
the estimated time remains at the
present value until the cycle step is
completed.
professional transport from one
location to another.
fabric care expert and/or
®
Advertisement
