D-Link DES-3326S Command Line Interface Reference Manual page 296

create ospf aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
To create an OSPF area aggregation:
DES-3326S:4#create ospf aggregation 10.1.1.1 10.48.76.122|16 lsdb_type
summary advertise enable
Command: create ospf aggregation 10.1.1.1 10.48.76.122|16 lsdb_type
summary advertise enable
Success.
DES-3326S:4#
D-Link DES-3326S Layer 3 Switch CLI Reference
Used to configure OSPF area aggregation settings.
create ospf aggregation <area_id>
<network_address> lsdb_type [summary]
{advertise [enable|disable]}
This command is used to create an OSPF area
aggregation.
<area_id> − A 32-bit number in the form of an IP
address (xxx.xxx.xxx.xxx) that uniquely identifies
the OSPF area in the OSPF domain.
<network_address> − The 32-bit number in the
form of an IP address that uniquely identifies the
network that corresponds to the OSPF Area.
lsdb_type [summary] − The type of address
aggregation.
advertise [enable|disable] − Allows for the
advertisement trigger to be enabled or disabled.
Only administrator-level users can issue this
command.
290