D-Link DES-3326S Command Line Interface Reference Manual page 231

create route redistribute dst ospf
Purpose
Syntax
Description
Parameters
Restrictions
Routing information source − RIP. the Static Route table, and the Local interface routing information. Routing
information will be redistributed to OSPF.
Route Source
RIP
Static
Local
Allowed Metric Type combinations are mettype 1 or mettype 2. The metric value 0 above will be redistributed
in OSPF as the metric 20.
Example Usage:
To add route redistribution settings:
DES-3326S:4#create route redistribute dst ospf src rip
Command: create route redistribute dst ospf src rip
Success.
DES-3326S:4#
D-Link DES-3326S Layer 3 Switch CLI Reference
Used to add route redistribution settings for the exchange of RIP routes to
OSPF routes on the Switch.
create route redistribute dst ospf src [static|rip|local] {mettype
[1|2]|metric <value>}
This command will redistribute routing information between the OSPF and RIP
routing protocols to all routers on the network that are running OSPF or RIP.
Routing information entered into the Static Routing Table on the local DES-
3326S Switch is also redistributed.
src [static|rip|local] − Allows for the selection of the protocol for the source
device.
mettype [1|2] − Allows for the selection of one of two methods of calculating
the metric value. Type-1 calculates (for RIP to OSPF) by adding the
destination's interface cost to the metric entered in the Metric field. Type-2
uses the metric entered in the Metric field without change. this field applies
only when the destination field is OSPF.
metric <value> − Allows the entry of an OSPF interface cost. This is
analogous to a Hop Count in the RIP routing protocol.
Only administrator-level users can issue this command.
Metric
0 to 16777214
0 to 16777214
0 to 16777214
Metric Type
mettype 1
mettype 2
mettype 1
mettype 2
mettype 1
mettype 2
225