Table of Contents
Advertisement
42. Install C12, 0.1 uF ceramic disc capacitor, next to R11.
43. Install S1, pushbutton switch, next to C1. Be sure to use enough
solder to hold it in securely.
44. Install D2, the 1N4002 diode, black with a stripe or band. Be sure to
orient the band with the PC board silkscreen marking or the Parts Layout
Diagram.
45. Install C9, 1000uF electrolytic capacitor. Again, be sure to line the
banded side up with the negative hole and the longer lead with the
positive hole, marked with a '+' sign. These caps tend to explode if
installed backwards so be careful.
46. Install D1, green LED, above SP1. Place it in so the flat side lines up
with the flat side on the circuit board drawing.
47. Install Infrared module U3. Don't worry about U4, It's for another type
of module that we used to pack with this kit. It did the same thing, but was
a different shape.
ICI2 Page 12
Advertisement
Table of Contents
