14.2.1
Connecting the Power Supply
Terminal Block
There is a two-pin screw-type terminal on the lower side of the OP housing
for connecting the power supply. The screw-type terminal is designed for
cables having a cross-section not larger than 2.5 mm
are accessible via drill holes in the rear panel.
figure 14-1 shows the location of the screw-type terminals on the OP7 and
OP17.
Figure 14-1 Connecting the Power Supply (View of Underside of OP)
Caution
!
Chassis ground
Connect the chassis ground
ground.
14-4
OP7
With a 24 V supply, make sure the extra-low voltage is isolated safely.
Use only power supplies complying with ICE 364-4-41 or HD 384.04.41
(DE 0100. Part 410).
The voltage supply must be within the permissible voltage range for the
device in question (see chapter C), otherwise it is not possible to exclude
the possibility of failures.
2
. The terminal screws
OP17
terminal block
on the bottom of the device to the cabinet
Equipment Manual OP7, OP17
Release 04/99