Setting The Beep Function - Icom iF3200DEX series Operating Instructions Manual

3
BASIC OPERATION

Setting the Beep function

The Beep function can be turned ON or OFF. When it is
OFF, the channel announcement is also turned OFF.
NOTE: You must turn ON the Beep function when
you set the microphone gain or the squelch level to
check the current level setting with the beep sound-
ing. (pp. 3-10, 3-11)
Rotate [VOL] to turn OFF the transceiver power.
q
Set [ROTARY SELECTOR] to any channel other
w
than Channel 16.
While holding down [Lower], rotate [VOL] to turn ON
e
the power to enter the Beep level adjustment mode.
Push [Lower] to turn the Beep function ON or OFF.
r
• When a beep sounds after pushing [Lower], the Beep
function is ON. When no beep sounds after pushing
[Lower], the Beep function is OFF.
• If desired, push [Upper] to adjust the Beep level. See
page 3-8 for details.
Rotate [VOL] to turn OFF the power to exit the Beep
t
level adjustment mode.
NOTE: This operation may not be available, depend-
ing on the presetting.
[Upper]
[Lower]
3-7
[ROTARY SELECTOR]
[VOL]