Porsche 928 S 1984 Owner's Manual page 81

Lifting car with car jack
The car should be jacked up only at the jack-
port points illustrated above and on preceding
page (black arrows).
WARNING
If work is to be done underneath the ve-
hicle, the car must be supported by suit-
able chassis stands or raised with a work-
shop hoist.
78
Lifting car with workshop hoist
Make sure there is sufficient clearance be-
tween pads and vehicle, before driving car on
hoist. The car must only be lifted at the lift
pad points illustrated on preceding page (white
arrows).
The rear lift points are located on the rear axle
control arm mount illustrated above (arrow).
Lifting car with floor jack
The same lift points illustrated for the hoist also
apply when using a floor jack. The rear end
of the car can also be lifted with a floor jack in
the center of the rear suspension cross mem-
ber. To avoid possible damage, it is recom-
mended to insert a wooden disk or a rubber
pad between the floor jack and the lift point
pads as illustrated above.
WARNING
The vehicle should never be jacked up
from underneath the engine oil pan or the
transmission. Severe damage could result.