Planet IGS-504HPT User Manual page 18

Fast/Gigabit Ethernet standard requires Category 5 UTP for 100Mbps 100Base-TX.
10Base-T networks can use Cat.3, 4, 5 or 1000Base-T uses 5/5e/6 UTP (see table
below). Maximum distance is 100 meters (328 feet). The 100Base-FX/1000Base-
SX/LX SFP slot is used as LC connector with optional SFP module. Please see table
below and know more about the cable's specification.
Port Type
10Base-T Cat 3, 4, 5, 2-pair
100Base-TX Cat.5 UTP, 2-pair
1000Base-T Cat.5/5e/6 UTP, 4-pair
50/125µm or 62.5/125µm multi-mode
100Base-FX
9/125µm single-mode
1000Base-SX/ 50/125µm or 62.5/125µm multi-mode
LX 9/125µm single-mode
Any Ethernet devices like hubs/PCs can be connected to the Industrial Gigabit
PoE+ Switch by using straight-through wires. The four 10/100/1000Mbps ports are
auto-MDI/MDI-X and can be used on straight-through or crossover cable.
2.1.6.1 Installing the SFP transceiver
The sections describe how to insert an SFP transceiver into the IGS-624HPT SFP
slot.
The SFP transceivers are hot-pluggable and hot-swappable. You can plug in and
out the transceiver to/from any SFP port without having to power down the
Industrial Gigabit PoE+ Switch as the Figure 2-3 appears.
MGB / MFB Series
Transceiver
 Approved PLANET SFP Transceivers
PLANET Industrial Gigabit PoE+ Switch supports both single mode and multi-mode
SFP transceivers. The following list of approved PLANET SFP transceivers is correct
at the time of publication:
18
Cable Type
Figure 2-3: Plug-in the SFP transceiver
Connector
RJ45
RJ45
RJ45
LC (multi/single mode)
LC (multi/single mode)