Table of Contents
Advertisement
43-685.fm Page 26 Thursday, July 8, 1999 7:50 AM
To clear a stored number, simply
store a new number in its place. Or,
press
twice. Then press the
MEM
memory location number (
want to clear. A tone sounds.
Use the supplied memory directory
sticker to record your stored numbers.
Peel the backing from the sticker and at-
tach it to the base.
Entering a Pause
In some telephone systems, you must
dial an access code (9, for example) and
wait for a second dial tone before you
can dial an outside number. You can
store the access code with the phone
number. However, you should also store
a pause after the access code to allow
the outside line time to connect.
To enter a 2-second pause, press
(
PAUSE
INTCM/PAUSE
For a longer pause, press it additional
times.
26
Reviewing Memory Numbers
(Handset Only)
–
) you
0
9
To review your memory numbers, press
MEMORY
ory location numbers (01–03) appears
with the name stored with each number
(or
name). If necessary, scroll through the
list by repeatedly pressing
entering the two-digit location number.
To view the stored phone numbers,
press
number means it is longer than 14 digits.
Press
number. Repeatedly press
to the name display.
To exit the memory number list, press
HOLD/CANCEL
To see a stored name and phone num-
ber at the same time, press
when the cursor is by a memory location
number. To exit this display without stor-
ing any changes, hold down
LETE
Dialing a Memory Number
To dial a number stored in the handset's
memory, lift the handset from the base
on the handset).
and press
three memory location numbers ap-
pears. Choose a memory location (01–
30) by pressing number keys or by re-
peatedly pressing
LINE 1
cally dials out the number.
. The list of the first three mem-
<Memory nn>
if you did not store a
. An arrow to the right of the
again to see the rest of the
.
until the display clears.
. The list of the first
MEMORY
or
or
. The ET-685 automati-
LINE 2
or
, or by
to return
SELECT
CONF/DE-
, then pressing
Advertisement
Table of Contents
