Using Remote Commands; Playing Back The Messages; Deleting All The Messages In A Mail Box - Radio Shack 900 MHz Digital Spread Spectrum Cordless Phone with Digital Answerer and Caller ID/Call Waiting Deluxe Owner's Manual

Using Remote Commands

Follow these steps to operate the TAD from
a remote location.
Note: If you wait more than 15 seconds be-
tween key presses, the TAD sounds a long
beep and hangs up.
1. Dial your phone number and wait for the
TAD to answer. If the TAD is not set to
answer calls, it will answer after about
10 rings and sound a series of beeps.
2. When the outgoing message begins (or
the TAD sounds a series of beeps),
press , then enter your security code
#
within 2 seconds.
3. If the code is
announces the day and time, then
announces the number of new and old
messages for each mail box, then "To
play incoming message, press pound
two. For help, press pound zero."
Note: The TAD beeps about every 2
seconds, prompting you to enter remote
commands. This
prompt.
If the TAD does not respond, try entering
your code again. If you enter an incor-
rect code three times, the TAD beeps
and hangs up.
Notes:
• When the TAD is in remote operation, it
stops all answering functions and the
display on the base shows
resumes answering functions when it is
no longer in remote command if you
have not turned it off.
• The remote operation stops when some-
one picks up the handset or any phone
on the same phone line.
28

Playing Back the Messages

correct, the TAD
is the command
Note: The remote playback of incoming
messages is limited to 4 minutes. If you have
more messages after 4 minutes have
passed, you must press
the rest of the messages.
h9 h9 h9 h9
. The TAD
Deleting All the Messages in a
Mail Box
At the command prompt, press
announces "Please select mail box." Press
and the mail box number. The TAD deletes
all the messages in the selected mail box
and announces "Deleted."
Answering System Operation
1. At the command prompt, press
TAD announces "Please select mail
box."
2. Press and the mail box number. For
#
example, to listen to the messages in
mail box 1, press , .
# 1
The TAD announces the mail box num-
ber and starts playing back new mes-
sages. If the selected mail box does not
contain new message, any old mes-
sages play. If it does not have any mes-
sage, the TAD announces "You have no
messages."
3. To skip the message, press
ten again to the current message, press
, . If you press ,
# 1 # 1
onds after a message begins playing,
the TAD replays the previous message.
If the current message is the first new
message, the TAD plays back from the
beginning of the current message (it
does not play old messages).
To stop playback and return to the com-
mand prompt mode, press
To delete the current message, press
during playback.
4
,
#
, . The
# 2
, . To lis-
# 3
within about 4 sec-
# , 5 .
,
#
again to listen to
2
, . The TAD
# 4
,
#