Oreck UK2200 User Manual page 7

Maintenance: Checking & Replacing
Brushroll Belt
LUBRICATION
The motor and brushroll are equipped with bearings which contain sufficient lubrication for their
lifetime. The addition of lubricant could cause damage. Do not add lubricant to motor or brushroll.
1 2
Remove the service
door by removing
the hold down screw
located on side of
power head.
4 5
Loop the new belt over
the motor shaft. Place
the opposite end of the
belt on the brushroll
pulley.
CAUTION
TO REDUCE THE RISK OF ELECTRIC SHOCK AND INJURY FROM MOVING PARTS - UNPLUG
BEFORE SERVICING.
12
3
Slide the door forward Remove the brushroll
by prying open with a belt from the motor
screwdriver or coin. shaft and brushroll
pulley.
6
Rotate the brush roll Replace the door
three (3) complete by sliding it into the
revolutions to ensure groove at the bottom
that no part of the belt of the housing. Replace
is overhanging the end the hold down screw.
of the motor shaft.
Maintenance: Clearing Blockages
LUBRICATION
The motor and brushroll are equipped with bearings which contain sufficient lubrication for their
lifetime. The addition of lubricant could cause damage. Do not add lubricant to motor or brushroll.
1 2
An overloaded Also, check for
filtration bag may blockages in the
cause dirt and debris power head nozzle.
to back up into the air If you can't reach the
flow system. Open the blockage, remove
bag dock and check the baseplate.
for visible clogs at the
bag port.
Change filtration bag
if contents have
reached the
MAXIMUM FILL LINE.
4
Twist lower
tube connector
counterclockwise
and slide up. Pull the
lower tube (A) out of
the fan housing. Once
removed, check for
blockage.
WARNING
TO REDUCE THE RISK OF ELECTRIC SHOCK AND INJURY FROM MOVING PARTS - UNPLUG BEFORE
CLEANING OR SERVICING.
3
If blockage is not in
the power head nozzle,
remove the lower tube.
Unhook the case clasp
releasing the filtration
bag case.
5
If the lower tube is
not blocked, look into
the fan housing (B) for
blockage. Be sure to
reassemble lower tube
and tighten the lower
tube connector before
continuing use.
13